Dewalt N474607 Stator & Module

The Dewalt N474607 Stator & Module combines the stationary motor winding with the electronic control module in equipment saws. These components work together to regulate motor operation, electrical output, and startup operations during normal cutting applications.

Common issues:

• Motor fails to start after the power switch is pressed.

• Saw loses power unexpectedly while cutting.

• Burnt stator windings produce a strong electrical odor.

• Electronic module causes intermittent motor operation.

• Motor repeatedly trips the circuit breaker during startup.

Motor Does Not Start

Quick Check: Verify power reaches the motor and inspect the stator and module connections for damage.

Fix Suggestion: Replace the stator and module assembly if electrical testing confirms an open winding or failed control module.

Prevention Tip: Operate the saw with the correct supply voltage and inspect wiring connections regularly.

Motor Cuts Out During Operation

Quick Check: Run the saw without load and observe whether the motor shuts off unexpectedly.

Fix Suggestion: Install a new stator and module if the electronic control interrupts power despite normal operating conditions.

Prevention Tip: Keep the motor housing free of excessive dust to promote proper cooling.

Burning Odor from the Motor

Quick Check: Examine the stator windings for discoloration or damaged insulation.

Fix Suggestion: Replace the assembly if overheating has damaged the windings or electronic module.

Prevention Tip: Avoid overloading the saw with cuts beyond its recommended capacity.

Circuit Breaker Trips Repeatedly

Quick Check: Test the stator windings for continuity and inspect the module for electrical faults.

Fix Suggestion: Replace the stator and module assembly if internal electrical failure is detected.

Prevention Tip: Periodically inspect the motor for signs of overheating and address electrical issues promptly.

Customer Experience: My table saw had intermittent power and eventually stopped starting altogether. After installing the Dewalt N474607 Stator & Module, the motor started smoothly and operated consistently throughout operations.