Mtd 711-05035 Tiller Drive Shaft Cutter Bar

The Mtd 711-05035 Tiller Drive Shaft Cutter Bar helps maintain consistant power transfer within compatible tiller transmission assemblies. Wear, debris, or improper alignment can reduce drive performance and affect tilling efficiency.

This part fixes the following symptoms:

• Tines rotate inconsistently during operation.

• Grinding noise from the drive system.

• Excessive vibration while tilling.

• Reduced power transfer to the tines.

• Drive shaft engagement feels loose.

Tines Rotate Inconsistently

Quick Check: Inspect the cutter bar for wear, dirt buildup, or improper engagement with the drive shaft.

Fix Suggestion: Clean the drive components, ensure proper alignment, and tighten any loose hardware affecting engagement.

Prevention Tip: Keep the drive system clean and inspect components before each tilling season.

Grinding Noise from the Drive System

Quick Check: Listen for noise while checking the cutter bar and surrounding drive components for debris or wear.

Fix Suggestion: Remove trapped debris, lubricate applicable moving parts, and inspect mating components for excessive wear.

Prevention Tip: Clean the transmission area after use to prevent dirt accumulation.

Excessive Vibration While Tilling

Quick Check: Check that the cutter bar is securely mounted and not bent.

Fix Suggestion: Tighten loose fasteners, verify proper alignment, and inspect the cutter bar for visible damage that could affect operation.

Prevention Tip: Avoid striking rocks, roots, and other hard obstacles while tilling.

Reduced Power Transfer to the Tines

Quick Check: Inspect the cutter bar and drive shaft connection for wear or improper engagement.

Fix Suggestion: Ensure the drive components are correctly installed and free of excessive wear. Replace only damaged components if inspection confirms failure.

Prevention Tip: Perform routine inspections of the drive system and address minor wear before it affects performance.

Customer Experience: After cleaning the Mtd 711-05035 drive assembly and installing this cutter bar, my tiller delivered smoother power to the tines with much less vibration.